Ecc99

KATALîG HOTOVø-novù dizajn

KATALîG HOTOVø-novù dizajn. www.jj-electronic.sk 15 Dimension and connections: 14 ECC99 www.jj-electronic.sk ECC99 R. F. DOUBLE TRIODE Base: NOV AL U f =6,3 or 12,6 V I f =800 or 400 mA Typical characteristic: U a =150 V U g =-4 V I a =18 mA S=9,5 mA/V R i =2,3 kΩ µ=22 Limiting values: U a ...

www.jj-electronic.sk

SRM-600 limited driver unit with vacuum tube output Output ...

SRM-600 limited driver unit with vacuum tube output Output stage employing high-power dual triode "ECC99" All-new driver unit with "ECC99" high-power dual triode on board - designed for best dynamism and vividness of sound.

www.knokki.com

Clarion: A Simple 2A3 Design Project

I chose the robust 5687 (closest modern equivalent is the ECC99) for this purpose, as it has low output impedance and superb sonics. You can also use a Russian 6H30, although it has a different pinout.

www.hagtech.com

MOTION PLANNING AND NONLINEAR SIMULATIONS FOR ATANK ...

MOTION PLANNING AND NONLINEAR SIMULATIONS FOR ATANK CONTAINING A FLUID Fran¸cois Dubois Conservatoire National des Arts et M´etiers 15, rue Mar at, 78210 Saint Cyrl' ´ Ecole Cedex, France [email protected] Nicolas Petit, Pierre Rouchon Centre Automatique et Syst`emes ´ Ecole Nationale Sup ...

cas.ensmp.fr

Stax SR-404 Electrostatic Headphone Amplifier

Page: 1 # 8 Author: Doede Douma Rev: 2.2 AuriDux Amplifier Update: 23-02-2004 Built: Design ready: YES YES ESL GND 2SK1058 TL431 R9 200E P2 200E R13 10k R12 100E 180V VB-Left 420 Volt Cooling 30K/W Tube2 ECC99-a ECC99-b R7 3k9 / 2W R6 1k R14 1k R15 3k9 / 2W Tube1 ECC99-a ECC99-b C1 100n C4 100n R2 100k R16 100k VB Left -20 Volt Bias 580 ...

www.dddac.de

MAD Ear+ Purist HD150 Special Edition Headphone Amplifier

Measured Performance (33 Ω Ω Ω Ω load, Tung-Sol 12AX7 and JJ ECC99 tubes) Maximum undistorted output at 1 kHz: 1.8 V rms (100 mW across 33 Ohms) 100 mW into 33 Ohm load overload characteristic (120 mW) Maximum voltage gain: 11 dB (62 dB power gain with 33 Ohm load) Output impedance at 1 kHz : less than 3 ...

hollowstate.netfirms.com

Simple EL84 Basic layout

•Hammond output transformer, particularly the 1650x series. •using one half of ECC99 for each channel. You could, of course, opt to use one tube for both channels, or use some other tube, say 5687.

www.diyparadise.com

iGrafx Designer 1 - Aikido LV

Where the tbe-based lineypical tu-stage amplifier requires a B+ of 200V to 400V, the LV Aikido can get by with only 24Vdc with 6GM8/6N27P/ECC86 tubes; or 48Vdc with 12BH7 or ECC99.

tubecad.com

JJ 828 Integrated power tube stereo amplifier

... sensitivity: 0,775 V for full output * Input impedance: 25 000 Ohms * Power bandwidth: 20 Hz - 25 000 Hz (-1 dB) * Noise & hum: - 88 dB bellow full output * Inputs: 5 x Line (unbalanced) * Tape out: For tape recording * AC power: 230 V (120 V, 100 V) AC 50/60 Hz * Consumption: 400 W max. * Tubes: 8 x JJ KT88, 2 x JJ ECC99 ...

www.jj-electronic.com

Musical Concepts Chameleon

It uses a single twin triode(12AU7, 12AT7, ECC99 or others). It operates as a single-stage per channel grounded cathode voltage amplifier. With global feedback(FB) it is actually known as a Plate Follower circuit.

www.musicaldesign.com

Other sites you could try:

Find videos related to Ecc99