Weeps
PVC Weep Tubes
PVC Waterstop MSDS Page 1 of 3 PVC Weep Tubes MATERIAL SAFETY DATA SHEET Section I - PRODUCT IDENTIFICATION Manufacturer: BoMetals, Inc. Information Phone: 770-832-2000 141 Hammond Street Emergency Phone: 770-832-2000 Carrollton, GA 30117 Product Class: PVC COMPOUND - Rigid Hazard Ratings ...
www.bometals.com
Rytons Cavity Weeps and Slim Vents - (L2) - Issue 11
1 (L2) CI/SfB reference by RIBA SfB Agency (21.9) Xn6 . Wall Issue 11 . October 2010 GB . Manufacturer Rytons Cavity Weeps and Slim Vents ® Air Bricks, Underfloor Vents and Cowls
www.rytons.com
Masonry Opening
Just as in cavity walls, it is important in single wythe walls to allow any water which does get into the wall to drain down to the flashing, where it will be collected, and exit through the weeps.
www.na.graceconstruction.com
ITEM 17203.9902 M - CRUSHED STONE WEEP
ITEM 17203.9902 M - CRUSHED STONE WEEP 03/03/95 02/15/96 Revised 03/04/96 DESCRIPTION Under this item, the Contractor shall construct crushed stone weeps of the type, and at locations as shown on the plans, or as directed by the Engineer.
www.dot.ny.gov
TECHNICAL DATA SHEET
Warranty & Maintenance: Sandell®'s Plastic Weeps carry a manufacturer's warranty of material specification compliance. Sandell®'s Plastic Weeps should not require maintenance if installed in accordance with Sandell®'s specifications and instructions.
sandellmfg.com
HORIZONTAL WEEP
Shape the main body over the face of the flashing so that the lower edge will align along where the back of the exterior finish will be and with the ends of the weeps extending beyond where the face of the exterior finish will be.
www.polyguardproducts.com
Optional Flashing Details
A bead of Bituthene ® is run along the top edge of the flashing on the backup wythe to enable it to shed any water running down that wythe onto the polyethylene flashing surface and to the weeps.
www.na.graceconstruction.com
Tech Brief_Sill Flashing
Weeps can be installed in sill head joints or between the sill and the flashing. Examples of under sill weeps may include: rope wicks, tubes, half-tubes, or cell vents lying on their sides.
www.imiweb.org
Builder Notes
Weeps should be placed directly above the flashing to help water drain from the wall. These weeps are often open head joints, but they can be vents as well.
www.bruderinc.com
DIVISION 04 - MASONRY
[____] finish Anchors: [Stainless] [Galvanized] steel Flashings: [Rubberized asphalt] [Copper] [Stainless steel] [____] type Weeps: Preformed type at maximum [32] [__] inches on center above flashings Mortar dropping control: Mesh type Pointing mortar joints: [Concave] [____] profile 04 7200 Cast Stone ...
www.spexplus.net
Other sites you could try:
Find videos related to Weeps