National Board Inspection Code
NB-240, Rev. 10 Page 1 of 24 National Board Inspection Code Procedure Approved by NBIC Committee: August 31, 2010 Approved by the Board of Trustees: October 18, 2010
FORM R-1 REPORT OF REPAIR in accordance with provisions of the National Board Inspection Code This form may be obtained from The National Board of Boiler and Pressure Vessel Inspectors, 1055 Crupper Ave., Columbus, OH 43229 NB-66 Rev. 12 1.
FORM R-1 REPORT OF REPAIR in accordance with provisions of the National Board Inspection Code 1. Work performed by: (name of repair organization) (Form R No.) (PO No., Job No., etc..)
(36) "NBIC" means national board inspection code. (37) "New boiler" means a boiler constructed, installed, placed in operation, or contracted for after July 1, 1966.
... and installed according to ASME Codes and are subject to meeting the inspection and certification requirements of the National Board Inspection Code, ANSI/NB-23.
REPLACEMENT OF STAMPED DATA FORM in accordance with provisions of the National Board Inspection Code Submitted to Submitted by (name of jurisdiction) (name of owner) (address) (address) (telephone n0.(telephone no.)
vessel to a safe and satisfactory operating condition, as defined in National Board Inspection Code, part 3, section 9. State boiler inspector.
Prepare a Quality Control Program following the requirements of the National Board Inspection Code and/or ASME as applicable. Assistance in developing the QC Program and training in its implementation can be obtained from Sperko Engineering Services, ...
... Division 225 Building Codes Division 1 of 2 Table 2-B Oregon Amendments to the 2007 Edition of the National Board Inspection Code ANSI/NB 23, part 1 Section 1.3, (d) ...
... and Modification of DOT Transport Tanks'') of the 2007 edition of the National Board Inspection Code for public review at www.nationalboard.org.
Other sites you could try:
Find videos related to National Board Inspection Code