RTCA DO-160F Lightning Testing

1 The world leader in serving science RTCA DO-160F Lightning Testing Overview, updates, changes and what's coming next! Michael Hopkins 2 RTCA DO 160 * RTCA is the Radio Technical Commission for Aeronautics •Publishes DO 160 • Latest is DO 160F, issued in December 2007 and now available ...

Subject: RTCA Document DO-160 versions

U.S. Department of Transportation Federal Aviation Administration Advisory Circular Subject: RTCA Document DO-160 versions D, E and F, "Environmental Conditions and Test Procedures for Airborne Equipment" Date: 11/19/09 Initiated by: AIR-100 AC No: 21-16F 1.

What's all this DO-160 Stuff Anyhow?

Robert L. Nuckolls, III AeroElectric Connection 8 May 2001 Updated 7 April 2006 Page 1 What's all this DO-160 Stuff Anyhow? Bob, am building a couple pieces of avionics - just some simple things, not critical to flight - and was re-reading your essay on doing without the avionics master switch ...

DO -160-WP-2005-1030 30 October 2005

DO -160-WP-2005-1030 30 October 2005 RTCA Special Committee 135 Environ mental Conditions and Test Procedures for Airborne Equipment Meeting #2 for Rev F Susceptibility Comparisons using Spot Illumination, TEM Cell and Line Conducted Injection Prepared by George Cooley Garmin SUMMARY This paper ...


DO-160 is the specification that sets the requirements for the aviation industry for electrical systems. It’s interesting that, in general, DO-160 usually only makes

Circuit Protection Application Note

However, in this document, to distinguish the DO-160 lightning transient from a typical GR-1089 lightning transient, this document will refer to the high-frequency DO-160 requirements as "burst" or "burst risetime.

Environmental Conditions and Test Procedures for Airborne ...

The current DO-160 nomenc lature began in 1975 and endorsement by the International Organization for Standardization (ISO) as ISO 7137 began in 1987.

Line Impedance Stablization Networks

... DO-160 and Mil Std. 461/ 462 Rev C, D and E. The LISN must maintain a characteristic impedance to the EUT and isolate the EUT from unwanted RF signals on both DC and AC power source while allowing the necessary voltage and current to be delivered to the EUT.

News from the Lab

Section 16: Power Input DO-160 changed Power Input more than any other section - there now are more requirements and categories. The additional AC categories distinguish between constant and variable frequency systems.


The FGDS-20A-50V complies with major standards including : • the US MIL-STD-461 rev D, E and rev F • the international DO-160 rev C, D, E and rev F In particular, ...

Other sites you could try:

Find videos related to Do-160