3406e Injector Adjustment

3406E, C-10, C-12, C-15, and C-16 ON-HIGHWAY ENGINES

132 SEBU7186-08 Maintenance Section Maintenance Interval Schedule i02574074 Maintenance Interval Schedule (3406E, C-15, and C-16 ... Adjust the electronic unit injector at the same interval as the valve lash adjustment.

safety.cat.com Find related...

P-39A - CATERPILLAR 3406E/C-15/C-16 PROBLEM DETECTION REPAIR ...

P-39A - CATERPILLAR 3406E/C-15/C-16 PAGE 1/4 (A) Electrical Fault: Confirm "CEL" (check engine light) only comes on when Pacbrake is applied. ... -When solenoid is activated each master piston link should extend into injector rocker cavity and engine braking should take place.

www.pacbrake.com Find related...

3406E, C-10, C-12, C-15, and C-16 ON-HIGHWAY ENGINES

COM 3406E, C-10, C-12, C-15, and C-16 ON-HIGHWAY ENGINES Engine Safety Excerpted from Operation & Maintenance Manual (SEBU7186-08-01) © 2007 Caterpillar ... SEBU7186-08 9 Safety Section Safety Messages Unit Injectors g00467451 Illustration 1 The warning label for the electronic unit injector is typically located ...

safety.cat.com Find related...

TDI Injector/Nozzle Swap Howto Copyright 2003 by Davin ...

TDI Injector/Nozzle Swap Howto Copyright 2003 by Davin Swanson, davin.swanson@earthlink.net Special thanks to KERMA for supplying the nozzles, to ... two ECU adjustments relating to fuel and air delivery that are relevant when changing to larger injectors: idle injection quantity and EGR adjustment.

pics.tdiclub.com Find related...

Series II Wheel Dozer

Caterpillar 3406E Engine. Is a six-cylinder, turbocharged, air-to-air aftercooled (ATAAC), Electronic Unit ... Electronic Unit Injector (EUI). Is a high-pressure, direct injection fuel system that is virtually adjustment-free.

www.huntraco.hu Find related...

Monaco Tool

... Exhaust Manifold Stud Removal Kit-CAT 3400 Series Heads 316.18 10 10140 Nozzle Puller (Slide Hammer Style) 106.18 3 10150 Trigger Adjustment Kit ... 501.41 3 10210-A Ring Compressor-Cat 3400 Series (5.4" Bore) (*PT 7040) 227.90 16 10220 CAT Lifter Tool(*5P-7433) 442.42 5 10221 Injector Timing Fixture - Cat 3406E (*9U ...

www.monacotool.com Find related...

NOTE: When setting valve lash clearance or injector height ...

Cylinder with Valve Overlap Set Valves on Cylinder No. Set Injector Height on Cylinder No. 6 1 5 2 5 3 4 3 6 1 6 2 5 2 4 3 4 1 Table 12-2a Valve Lash and Injector Height Adjustment Sequence NOTICE: Never set the valves and injector of the same cylinder at the same time.

ww2.justanswer.com Find related...

Monaco Tool

... Exhaust Manifold Stud Removal Kit-CAT 3400 Series Heads 298.28 10 10140 Nozzle Puller (Slide Hammer Style) 100.17 3 10150 Trigger Adjustment Kit ... gear group 473.03 3 10210 Ring Compressor-Cat 3400 Series (5.4" Bore) (*PT 7040) 254.88 10 10220 CAT Lifter Tool(*5P-7433) 417.38 5 10221 Injector Timing Fixture - Cat 3406E ...

www.dieselenginetools.com Find related...

3406 B/C PEEC Repair Manual

Differences-3406E/C-15/C-16 - Directly fires each injector.-3406E/C-15/C-16 - Determines fuel rate by injector "on time".-3406E/C-15/C-16 ... This adjustment may have to be performed several times before both low and high idle adjustment ranges are achieved at the same time.

ww2.justanswer.com Find related...

Engine Valve Lash - Inspect/Adjust

Refer to Testing and Adjusting, "Unit Injector - Adjust". (1) Valve (2) Rocker arm (3) Adjustment locknut (4) Adjustment screw Copyright 1993 - 2010 Caterpillar Inc. Página 4 de 5 135H Motor Grader 8WN00001-UP (MACHINE) POWERED BY 3116 Engine(SEBP... 06/04/2010 https://sis.cat. com/sisweb/sisweb/techdoc ...

partesytractores.com Find related...

Other sites you could try:

Find videos related to 3406e Injector Adjustment